03-M-E3B, 03-M-DI-E3B, 03-M-E3BG WSM DIESEL ENGINE Cylinder Head 1. Loosen the pipe clamp (2), and remove the water return pipe (1). 2. Remove the cylinder head screw in the order of (n or r) to (a) . 3. Lift up the cylinder head (3) to detach. 4. Remove the cylinder head gasket (4). (When reassembling) Replace the cylinder head gasket (4) with a new one. Tighten the cylinder head screws after applying sufficient oil. Tighten the cylinder head screws in diagonal sequence starting from the center in the order of (a) to (n or r) . Tighten them uniformly, or the head may deform in the long run.
IMPORTANT Q To replace the cylinder head gasket (4), in advance make sure the marking (5) of cylinder head gasket in the original engine, and replace the same marking as the original cylinder head gasket. (1) Return Pipe (2) Pipe Clamp (3) Cylinder Head (4) Cylinder Head Gasket (5) Marking (n or r) to (a) : To Loosen (a) to (n or r) :
To Tighten (A) Gear Case Side (B) Flywheel Side W1112015 S-51 KiSC issued 07, 2008 A Tightening torque Cylinder head screw 93.2 to 98.0 N·m 9.50 to 10.0 kgf·m 68.8 to 72.3 lbf·ft Gasket Marking & Code Number Model D1503-M D1703-M D1803-M D1803-M-DI V2003-M V2203-M V2403-M V2403-M-T V2403-M-DI V2403-M-DI-T 15 1G720-03600 1G750-03600 1G464-03600 1G790-03600 20 1G720-03310 1G750-03310 1G464-03310 1G790-03310 25 1G720-03610 1G750-03610 1G464-03610 1G790-03610 30 1G720-03620 1G750-03620 1G464-03620 1G790-03620 35 1G720-03630 1G750-03630 1G464-03630 1G790-03630 Gasket Marking & Code Number Model D1703-M-BG V2003-M-BG V2003-M-T-BG V2203-M-BG V2403-M-BG 15 1G750-03600 1G464-03600 1G770-03600 1G790-03600 20 1G750-03310 1G464-03310 1G770-03310 1G790-03310 25 1G750-03610 1G464-03610 1G770-03610 1G790-03610 30 1G750-03620 1G464-03620 1G770-03620 1G790-03620 35 1G750-03630 1G464-03630 1G770-03630 1G790-03630