Kubota — SERVICING

03-M-E3B, 03-M-DI-E3B, 03-M-E3BG WSM DIESEL ENGINE Injection Pump (for Turbocharger Model) 1. Remove the boost compensator assembly (2). 2. Remove the hi-idling body (4). 3. Remove the solenoid (3). 4. Remove the solenoid guide (5). 5. Remove the injection pump assembly (1). IMPORTANT Q Before removing the injection pump assembly (1), be sure to remove the boost compensator assembly (2), hi-idling body (4), solenoid (3) and solenoid guide (5). (When reassembling) Before attaching the boost compensator assembly (2), hi-idling body (4), solenoid (3) and solenoid guide (5), install the injection pump first into position. Replace the hi-idling body gasket with a new one.

Before fitting the boost compensator assembly (2) to the gear case, make sure that the solenoid guide (5) is at the initial position. When installing the solenoid (3), be careful to keep the O-ring in place. Be sure to insert the push rod of the solenoid into the hole at the center of the solenoid guide (5). IMPORTANT Q If you replace new boost compensator, it is necessary to adjust it. Get the adjustment procedure from KUBOTA. (1) Injection Pump Assembly (2) Boost Compensator Assembly (3) Solenoid (4) Hi-idling Body (5) Solenoid Guide W1032355 S-55 KiSC issued 07, 2008 A Tightening torque Hi-idling body 45 to 49 N·m 4.5 to 5.0 kgf·m 33 to 36 lbf·ft