03-M-E3B, 03-M-DI-E3B, 03-M-E3BG WSM DIESEL ENGINE [3] SERVICING (1) Cylinder Head and Valves Top Clearance 1. Remove the cylinder head. 2. Move the piston up and stick a strip of fuse on the piston head at three position with grease. 3. Lower the piston and install the cylinder head. (Use a new cylinder head gasket and tighten with a specified tightening torque.) 4. Turn the flywheel until the piston exceeds top dead center. 5. Remove the cylinder head and measure the thickness of the fuses. 6. If the measurement is not within the factory specifications, check the oil clearances between the crankpin and bearing and between the piston pin and bushing.
NOTE Q After checking the top clearance, be sure to assemble the cylinder head with a new cylinder head gasket. (1) Piston (2) Fuse [A] D1503-M, D1703-M, D1803-M V2003-M, V2203-M, V2403-M V2403-M-T D1703-M-BG, V2003-M-BG V2003-M-T-BG, V2203-M-BG V2403-M-BG [B] D1803-M-DI, V2403-M-DI V2403-M-DI-T W1020190 S-73 KiSC issued 07, 2008 A Top clearance Factory spec. D1503-M D1703-M D1803-M V2003-M V2203-M V2403-M V2403-M-T D1703-M-BG V2003-M-BG V2003-M-T-BG V2203-M-BG V2403-M-BG 0.575 to 0.675 mm 0.0227 to 0.0265 in. D1803-M-DI V2403-M-DI V2403-M-DI-T 0.60 to 0.70 mm 0.024 to 0.027 in. Tightening torque Cylinder head screws 93.2 to 98.0 N·m 9.50 to 10.0 kgf·m 68.8 to 72.3 lbf·ft