03-M-E3B, 03-M-DI-E3B, 03-M-E3BG WSM DIESEL ENGINE Oil Clearance between Crankshaft Journal and Crankshaft Bearing 1 1. Measure the O.D. of the crankshaft journal with an outside micrometer. 2. Measure the I.D. of the crankshaft bearing 1 with an inside micrometer, and calculate oil clearance. 3. If the clearance exceeds the allowable limit, replace the crankshaft bearing 1. 4. If the same size bearing is useless because of the crankshaft journal wear, replace it with an undersize one referring to the table and figure. (Reference) Undersize dimensions of crankshaft journal W1033717 Replacing Crankshaft Bearing 1 (When removing) 1.
Press out the used crankshaft bearing 1 using a crankshaft bearing 1 replacing tool. (See page “SPECIAL TOOLS” .) (When installing) 1. Clean a new crankshaft bearing 1 and crankshaft journal bore, and apply engine oil to them. 2. Using a crankshaft bearing 1 replacing tool, press in a new bearing 1 (2) so that its seam (1) directs toward the exhaust manifold side. (See figure.) (1) Seam (2) Crankshaft Bearing 1 (3) Cylinder Block (A) Dimension W1033946 S-92 KiSC issued 07, 2008 A Oil clearance between crankshaft journal and crankshaft bearing 1 Factory spec. 0.0400 to 0.118 mm 0.00158 to 0.00464 in. Allowable limit 0.20 mm 0.0079 in. Crankshaft journal O.D. Factory spec.
59.921 to 59.940 mm 2.3591 to 2.3598 in. Crankshaft bearing 1 I.D. Factory spec. 59.980 to 60.039 mm 2.3615 to 2.3637 in. Undersize 0.2 mm 0.008 in. 0.4 mm 0.02 in. Dimension A 2.8 to 3.2 mm radius 0.11 to 0.12 in. radius 2.8 to 3.2 mm radius 0.11 to 0.12 in. radius *Dimension B 1.0 to 1.5 mm relief 0.040 to 0.059 in. relief 1.0 to 1.5 mm relief 0.040 to 0.059 in. relief Dimension C 59.721 to 59.740 mm dia. 2.3513 to 2.3519 in. dia. 59.521 to 59.540 mm dia. 2.3434 to 2.3440 in. dia. (0.4S) The crankshaft journal must be fine-finished to higher than ∇∇∇∇ *Holes to be de-burred and edges rounded with 1.0 to 1.5 mm (0.040 to 0.059 in.) relief. Dimension (A) Factory spec.
4.20 to 4.50 mm 0.166 to 0.177 in.