Kubota — SERVICING

03-M-E3B, 03-M-DI-E3B, 03-M-E3BG WSM DIESEL ENGINE (5) Cylinder Cylinder Wear 1. Measure the I.D. of the cylinder at the six positions (see figure) with a cylinder gauge to find the maximum and minimum I.D.’s. 2. Get the difference (Maximum wear) between the maximum and the minimum I.D.’s. 3. If the wear exceeds the allowable limit, bore and hone to the oversize dimension. (Refer to “Correcting Cylinder” .) 4. Visually check the cylinder wall for scratches. If deep scratches are found, the cylinder should be bored. (Refer to “Correcting Cylinder” .) A : Top B : Middle C : Bottom (Skirt) (a) Right-angled to Piston Pin (b) Piston Pin Direction W1034389 S-95 KiSC issued 07, 2008 A Cylinder I.D.

Factory spec. D1503-M V2003-M V2003-M-BG V2003-M-T-BG 83.000 to 83.022 mm 3.2678 to 3.2685 in. D1703-M D1803-M V2203-M V2403-M V2403-M-T D1803-M-DI V2403-M-DI V2403-M-DI-T D1703-M-BG V2203-M-BG V2403-M-BG 87.000 to 87.022 mm 3.4252 to 3.4260 in. Allowable limit D1503-M V2003-M V2003-M-BG V2003-M-T-BG 83.170 mm 3.2744 in. D1703-M D1803-M V2203-M V2403-M V2403-M-T D1803-M-DI V2403-M-DI V2403-M-DI-T D1703-M-BG V2203-M-BG V2403-M-BG 87.170 mm 3.4319 in.