Kubota — GENERAL

03-M-E3B, 03-M-DI-E3B, 03-M-E3BG WSM G GENERAL Replacing Oil Filter Cartridge (for 90 mm (3.5 in.) Depth Oil Pan) [D1503-M, D1703-M, D1803-M, V2003-M, V2203-M, V2403-M] [D1703-M-BG, V2003-M-BG, V2003-M-T-BG, V2203-M-BG, V2403-M-BG] CAUTION Be sure to stop the engine before replacing filter cartridge. 1. Remove the oil filter cartridge (1) with the filter wrench. 2. Apply a slight coat of oil onto the new cartridge gasket. 3. To install the new cartridge, screw it in by hand. Over tightening may cause deformation of rubber gasket. 4. After the new cartridge has been replaced, the engine oil normally decrease a little.

Thus see that the engine oil does not leak through the seal and be sure to read the oil level on the dipstick. Then, replenish the engine oil up to the specified level. IMPORTANT Q To prevent serious damage to the engine, replacement element must be highly efficient. Use only a KUBOTA genuine filter or its equivalent. (1) Engine Oil Filter Cartridge W1022423 G-16 KiSC issued 07, 2008 A