Kubota — GENERAL

03-M-E3B, 03-M-DI-E3B, 03-M-E3BG WSM G GENERAL Replacing Oil Filter Cartridge (for 124 mm (4.88 in.) Depth Oil Pan) [D1803-M-DI, V2403-M-DI, V2403-M-DI-T] CAUTION Be sure to stop the engine before replacing filter cartridge. 1. Remove the oil filter cartridge (1) with the filter wrench. 2. Apply a slight coat of oil onto the new cartridge gasket. 3. To install the new cartridge, screw it in by hand. Over tightening may cause deformation of rubber gasket. 4. After the new cartridge has been replaced, the engine oil normally decrease a little. Thus see that the engine oil does not leak through the seal and be sure to read the oil level on the dipstick.

Then, replenish the engine oil up to the specified level. IMPORTANT Q To prevent serious damage to the engine, replacement element must be highly efficient. Use only a KUBOTA genuine filter or its equivalent. (1) Engine Oil Filter Cartridge W1036519 Replacing Fuel Filter Cartridge (Cartridge Type) Water and dust in fuel are collected in the filter cartridge. So, change the filter cartridge every 400 hours service. 1. Remove the used filter cartridge with filter wrench. 2. Apply a thin film of fuel to the surface of new filter cartridge gasket before screwing on. 3. Then tighten enough by hand. 4. Loosen the air vent plug to let the air out. 5. Start engine and check for fuel leakage.

(1) Fuel Filter Cartridge W1050548 Replacing Fuel Filter Element (Element Type) 1. Close the fuel cock (3). 2. Unscrew the retaining ring (6) and remove the filter cup (5), and rinse the inside with kerosene. 3. Replace the filter element (4). 4. Reassemble the fuel filter, keeping out dust and dirt. 5. Bleed the fuel system. (1) Cock Body (2) Air Vent Plug (3) Fuel Cock (4) Filter Element (5) Filter Cup (6) Retaining Ring W1050583 G-22 KiSC issued 07, 2008 A