Kubota — GENERAL

03-M-E3B, 03-M-DI-E3B, 03-M-E3BG WSM G GENERAL Valve Seat Tightness [D1503-M, D1703-M, D1803-M, V2003-M, V2203-M, V2403-M, V2403-M-T] [D1703-M-BG, V2003-M-BG, V2003-M-T-BG, V2203-M-BG, V2403-M-BG] 1. Set the injection nozzle to a nozzle tester. 2. Raise the fuel pressure, and keep at 12.75 MPa (130.0 kgf/cm 2 , 1849 psi) for 10 seconds. 3. If any fuel leak is found, replace the nozzle piece. W10412730 [D1803-M-DI, V2403-M-DI, V2403-M-DI-T] 1. Set the injection nozzle to a nozzle tester. 2. Raise the fuel pressure, and keep at 16.67 MPa (170.0 kgf/cm 2 , 2418 psi) for 10 seconds. 3. If any fuel leak is found, replace the injection nozzle assembly.

W1037135 Nozzle Holder [D1503-M, D1703-M, D1803-M, V2003-M, V2203-M, V2403-M, V2403-M-T] [D1703-M-BG, V2003-M-BG, V2003-M-T-BG, V2203-M-BG, V2403-M-BG] 1. Secure the nozzle retaining nut (7) with a vise. 2. Remove the nozzle holder (1), and take out parts inside. (When reassembling) Assemble the nozzle in clean fuel oil. Install the push rod (4), noting its direction. After assembling the nozzle, be sure to adjust the fuel injection pressure. (1) Nozzle Holder (2) Adjusting Washer (3) Nozzle Spring (4) Push Rod (5) Distance Piece (6) Nozzle Piece (7) Nozzle Retaining Nut W1018491 G-30 KiSC issued 07, 2008 A Valve seat tightness Factory spec.

No fuel leak at 12.75 MPa 130.0 kgf/cm2 1849 psi Valve seat tightness Factory spec. No fuel leak at 16.67 MPa 170.0 kgf/cm2 2418 psi Tightening torque Nozzle holder 35 to 39 N·m 3.5 to 4.0 kgf·m 26 to 28 lbf·ft Overflow pipe retaining nut 20 to 24 N·m 2.0 to 2.5 kgf·m 15 to 18 lbf·ft Nozzle holder assembly 49 to 68 N·m 5.0 to 7.0 kgf·m 37 to 50 lbf·ft