Komatsu — CHECK BEFORE STARTING ENGINE

. OPERATION OPERATION CHECK WATER SEPARATOR, DRAIN WATER WARNING 1. Open the engine side cover on the left side of the machine. The water separator (1) forms one unit with the fuel pre-filter, and is at the bottom. 3 - 91 Each part of the engine is still highly heated immediately after the e ngine is stopped. Do not at tempt to drain cooling water or remove the filter element cup . High pressure is generated in side the engine fuel piping, while the engine is running. Wait for more than 30 seconds after the engine stop for the engine to sufficiently cool down. Then start with draining cooling water or r emoving the filter element cup. Do not bring fire close. 2.

It is possible to judge t he condition of water and sediment p (3). If water or sediment is through transparent ca accumulated, set a conta discharged water. is iner under drain hose (4) to collect the n the water. as fuel starts to be discharged from 0.45 Nm {0.02 - 0.046 kgm}) 3. Loosen plug (2) and drai 4. Tighten plug (2) as soon drain hose (4). (Tightening torque: 0.2 - REMARK (5) of plug (2) with grease. nder drain hose (4). drain all the sediment together with se (4). omes out from drain hose (4), then 5) with a suitable amount of grease. areful not to let the grease get on the in port (a) or the plug thread. hand until it contacts the bottom. tainer.

(3) is dirty and the contents cannot be easily seen, clean transparent cap (3) when If plug (2) is stiff, coat O-ring 1) Set a fuel container u 2) Loosen plug (2), then the fuel from drain ho 3) Check that nothing c remove plug (2). 4) Coat O-ring portion ( When doing this, be c drain valve water dra 5) Screw in plug (2) by 6) Remove the fuel con If transparent cap replacing the filter. When washing, if the bottom. plug (2) is removed, coat the O-rin g with grease, then tight en by hand until it contacts drain all the sediment together with areful not to let the grease get on the