. OPERATION OPERATION ADJUSTING WORK EQUIPMENT POSTURE shifting cylinder piston rod, as follows. the blade. Protrusion to right: Position (1) Protrusion to left: Position (2) Standard position: Center 3 - 155 Move the work equipm ent to the most suitable position fo r eac h operation a nd carry o ut operat ions efficie BLADE PROTRUSI The degree of protrus ontrol operation. If further p while and change the rotrusion is needed, stop grad er for a orizontal 1. Lower the blade to 2. Loosen the bolt ho lding the blade to the brac ket at the t ip of t he remove the bolt and lock 3. Retract or extend 4. Align the bolt hole 5. Install the lock wa sher and bolt, then tighten the bolt.
BLADE PROPULSI ON ANGLE e blade and the center line of the machine e propulsion angle. sion angle to about 60° for general cutting er in the following situations. sistance is high. rd. mulated in front of the blade dose not flow The angle between th body is called the blad Set the blade propul work, but set it narrow er in the following situatio When the cutting re When the soil is ha When the soil accu smoothly.