. OPERATION TROUBLESHOOTING TOWING THE MACHINE WARNING If any failure should occur in the brake system and the brakes will not work, then be extremely careful. If the machine is towed in the wrong way, there is the danger of an accident that could cause death or injury. Before releasing the brake, always put blocks under the wheels. Only use wire rope that has enough strength for the weight that it is being towed. Do not apply a load to the wire rope suddenly. WHEN ENGINE CAN BE USED Always keep the engine running when towing the machine, so that the steering and braking can be used.
3 - 178 NOTICE Towing is for moving the machine to a place where i nspection and maintenance can be carried out, and not for moving it long distances. The machine must not be towed for long distances. hen it has broken down, please contact your Komatsu distributor. For details of the procedure for towing a machine w WHEN ENGINE CANNOT BE USED When towing a disabled machine the distance should be within 600 m (1968 ft) at a speed of 8 km/h (5.0 MPH) or less. If the distance is more than the above mention ed, or if more than one day has elapsed since the engine trouble, be sure to use a trailer for transportation. fixed time after the engine stops.) The parking brake is automatically applied.
(A It is necessary to release the parking brake, bu special measures to ensure safety when movi t the brake will then have no effect at all, so it is necessary to take ng the machine. This is particularly important on slopes. NOTICE If the machine is towed without the engine running, no l ubrication oil will be supplied to the transmission. The gears and bearings are rotated, so this may cause them to be damaged. Tow the machine properly according to the ins tructions given below. The explanation given here is only to be used f or a machine that has failed and is to be moved to a safe place for repairs. It must be moved a maximum of 600 procedure is only for emergency purposes.
If t m (1968 ft) and at a maximum speed of 8 km/h (5.0 MPH). This he machine must be moved a long distance, use a transporter. To protect the operator if the towrope or bar s hould break, install a protector plate to the machine being towed. If it is impossible to use the steering or brakes on the machine being towed, then do not have anyone sitting in the operator's seat. Before towing, check that the tow rope or bar are in good condition, and that they have ample strength for the towing operation.
If the machine being towed or bar must be of a strength of at least 1.5 tim may get stuck in mud or may have to be towed uphill, the tow rope es greater than the weight of the machine being towed. Keep the angle of the towing line to the minimu m. Operate the machine so that the angle does not become greater than 30° from the straight line. If the machine is moved suddenly, the towrop e or bar will be subjected to an excessive load, and it may break. Start the machine gradually and travel at a co nstant speed. Normally, use a towing machine of about the same capacity as the machine being towed. The towing machine must have ample brake capacity, weight, and r on the tow road. impull.
Check that both machines can be controlled on slopes and