Komatsu — WHEN REQUIRED

. MAINTENANCE SERVICE PROCEDURE WHEN REQUIRED CLEAN INSIDE OF COOLING SYSTEM WARNING The coolant has the important function of preventing corrosion as well as preventing freezing. Even in the areas where freezing is not an issue, the use of antifreeze coolant is essential. Komatsu machines are supplied with Komatsu Supercoolant (AF-NAC). Komatsu Supercoolant (AF-NAC) has excellent anticorrosion, antifreeze and cooling properties and can be used continuously for 2 years or 4000 hours. As a basic rule, we do not recommend the use of any coolant other than Komatsu genuine supercoolant (AF-NAC).

If you use another coolant, it may cause serious problems, such as corrosion of the engine and aluminum parts of the cooling system. To maintain the anticorrosion properties of Supercoolant (AF-NAC), always keep the density of Supercoolant between 30% and 68%. Supercoolant (AF-NAC) is already diluted with distilled water. When using coolant, investigate the lowest temperatures in the past and decide the density for the coolant from the coolant density table below. When actually deciding the density for the coolant, set it for a temperature 10 ° C (18 ° F) lbelow the actual temperature. The coolant density varies according to the ambient temperature, but it must always be a minimum of 30%.

Coolant density table 4 - 18 Immediately after th e engine i s stopped, th e coolant is at a high temperatu re and th e radiator is under high interna l pressure. If the cap is r emoved to drain t he coolant in this condition, t here is a danger of burns. Wait for the temperatur e to go down, then turn t he cap slowly t o release the pressur e before removing it. The c leanin g is carr ied out wi th the engin e running. When standin g up or leaving t he operator's seat, set t he gear shift lever to the P (Parking) po sition. For d etails o f startin g the engi ne, see "CHECK BEFORE STARTING ENGIN E (PAGE 3-83)", "STARTING ENGINE (PAGE 3-101)" in the OPERATION s ection.

e machine when the engine is running. Neve r enter the area behind th e machine when the engine is running. Stop th e machine on level gr ound when cleaning or changing the coolant. Clean t he inside of t he coolin g system, change the coolant accordin g to the table below Antifreeze coolant Interval for cleaning inside of cooling system and changing antifreeze coolant Komatsu supercoolant (AF-NAC) Every two years or every 4000 hours whichever comes first Minimum Temp °C Above -10 -15 -20 -25 -30 -35 -40 -45 -50 °F Above 14 5 -4 -13 -22 -31 -40 -49 -58 Concentration (%) 30 36 41 46 50 54 58 61 64