. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE 2 , 28.4 PSI)) blow the and again times the inner the outer inner and body will be CAUTION 4 - 23 5. Blow dry com pressed air (Max . 0.20 MPa (2 kg/cm rom the insid e of the elemen compressed rom the insid 1) Replace t epeatedl y or used throug lement a t the same time 2) I f the yello w display panel of the dust indicator enter of the scale (5 kP a) immediately aft ed, replace both th lement h as been clean uter elem ents, even whe n the outer element h leaned 6 6.
I f small holes or thinner parts t is c hecked b y shining a light through it after clean he e NOTICE When cleaning th e element, do not hit it or beat it against D o not use an el ement whose folds or gasket or seal are If force is used when assembling, the clip or air cleaner damaged, so pus h it in straight wh en installing it. D o not operate t he machine with t he inner element remo damag e the engi ne. 7. Set t he clean ed outer elemen t and install dust cu p (4), then secure them with clips (3 If the inne r and oute r element have be en replaced, always re place O-ring (8) with a new 8.
Pres s the but ton on dust indic ator (1) to return the yellow displa y panel to its original position. 9. Clos e the eng ine side cover o n the right side of th e machine.