. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE 4 - 31 4. After th e cooling fan rev erse rotation p ilot lamp on the machin monito r flashes, check that it lights up . T he fan is set to rotat in reverse 5. Run th e engine at high Select the time for runn ing the engine at high idle as follows according t o the condition of clogging. Norma l clogging: 1 to 2 Excessive clogging: 2 t 6. When the cleaning is c ompleted, run the engine a t low i dling 7. Press position (B) of co oling fan reverse rotation switch 8. After th e cooling fan rev erse rotation p ilot lamp on the machin monito r flashes, check that it goes ou t. T he fan is set to rotat in the normal direction. 9.
Run th e engine at low i dling for approx. 10 secon NOTIC E of cleaning only by using the reverse rotation of the cooling fan, mud and dirt possibly remain. In case of cl eaning only by us ing the reverse r otation of the coolin g fan, mud and dirt possibly remai If switching the cooling fan rot ation to the normal direction i n this s tate, t he mud a nd d irt probably sti ck fast again to the fin, Afte r revers e rotations of the c ooling fan, stop the engine an d clear the r emaining mu d and dirt off by using compressed air broom, etc. confirm that there is no flammable material around hot portions of the engine.
In addition, confirm that there is no flammable material arou nd hot portions of the engine.