. MAINTENANCE SERVICE PROCEDURE CHECK OIL LEVEL IN TRANSMISSION CASE, ADD OIL WARNING water. 1. Stop the engine. NOTICE 4 - 47 Parts and oil are still heate d for some time after the engine stops. Start operations after the tempe Before the check, set the ge ar shift lever to the P (PARKING ) position to prevent the machine from m oving and confirm th at the respective levers are place Carry out this procedure if there is any sign of oil on th e transmission case, or if there is o il mixed with the co oling Wait for at least 12 hours after stopping the engine before carry ing out the i nspection.
If this is not done , there will be oil remaining at various places and it will be impossible to check the oil lev el correctly. 2. Remove cap of oil filler (F). G) and wipe off the oil with cloth. into filler pipe, then remove it. 3. Take out the dipstick ( G) and wipe off the oil with c loth. 4. Fully insert dipstick (G) into filler pipe, then remove 5. The oil level should be between the H and L marks on dipstick (G). If the oil level is below the L mark, add oil through o il filler port (F). 6. If the oil level is H line or above, remove drain plug (1), slowly loosen drain plug (2) to discharge the excess oil, and then n. then check the oil level agai Tightening torque drain plug (1):
59 to 78.5 Nm (6 to 8 kgm, 43.4 t o 57.9 lbft) drain plug (2): 49 to 78.5 Nm (5 to 8 kgm, 36.2 t o 57.9 lbft)