Komatsu — EVERY 500 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE (15) Pinion gear 4 - 60 Adjusting front and rear position Lower the blade lightly to t loosen locknut (4), turn back (2), and make (Q) F = 0. (W bolt (3), push open circle guide hen doing this, push open the left and right bolts uniformly.) 3. Adjust circle (14) fore and aft so that the clearance (D) between the lower flange (13) of the cir cle rotator and the sliding surface of inner circumference of the circle is 20 - 22 mm (0.8 - 0.9 in). 4. When (Q) F = 0, tighten lock Adjusting left and right positi on locknut (12), turn back bolt (11), nd make (Q) R = 0. (When doing 5.

Loosen bolt (9), then loosen push open circle guide (10), a 6. this, push open the left and r Loosen bolt (5), then loosen l ight bolts uniformly.) ocknut (8), turn back bolt (7), push open circle guide (6), and m ake (Q) C = 0. (When doing this, push open the left and right bolts uniformly.) 7. When (Q) R = 0, turn back b olt (11) half a turn, tighten locknut (12), return circle guide (10 tighten bolt (9). The clearance between the ) until it contacts bolt (11), then tip of the teeth of the circle gear 8. and the root of the teeth of th e pinion gear should be 1.5 - 3.0 mm (0.059 - 0.118 in). 9.

When (Q) C = 0, turn back bo lt (7) 1/4 of a turn, tighten locknut (8), return circle guide (6) un til it contacts bolt (7), then tighten bolt (5). e left and right at high bank. 10. Check that it rotates 90º to th