. MAINTENANCE SERVICE PROCEDURE PROCEDURE FOR BLEEDING AIR 1. Fill the fuel tank with fuel. 2. Open the engine side cover on the left side of the machine. 3. Loosen and pull out feed pump knob (1) and move it forward and backward. The plug on the side surface of the fuel pre-filter head does not need to be removed. Keep moving knob (1) until it becomes heavy. 4. After bleeding air, push in and tighten knob (1). REPLACE TRANSMISSION OIL FILTER CARTRIDGE WARNING Prepare a ring wrench 1. Set the container under the filter cartridge to catch the drained oil. 2. Using the ring wrench, turn filter cartridge (1) to the left to remove it. 3.
Clean the filter holder, coat the seal surface of the new filter cartridge thinly with clean engine oil, then install to the filter holder. Tightening torque: 49 to 59 Nm (5 to 6 kgm, 36.2 to 43.4 lbft) 4 - 62 7. When installing, tighten until the packing surface contacts the seal surface of the filter holder, then tighten i t 3/4 of a turn. If the filter cartridge is tightened too far, the packing will be damaged and filter cartridge is too loose, fuel will also leak from the packing, so always this will lead to leakage of fuel. I f the tighten the correct amount. PAGE 4-62)". 8. After completing replacement of filter cartridge (1), bleed the air from the system.
For details, see "PROCEDURE FOR BLEEDING AIR ( 9. After completing the air bleeding, start the engine and check that there is no leakage of fuel from the filter seal surface. If there is any leakage, check the tightening condition of the filter c repeat Steps 1 - 3 to remove the filter cartridge, then check the packing su If any damage or embedded dirt is found, replace the cartridge with a new it. artridge. If there is still fuel leakage, rface for damage or embedded dirt. part and repeat Steps 4 - 8 to in stall The parts and oil are at high temperature immediately after the engine is stopped, and m ay cause burns. Wait for the temperature to go down before starting the work.