. ATTACHMENTS, OPTIONS HANDLING BLADE ACCUMULATOR METHOD OF OPERATING BLADE ACCUMULATOR 1. Lower the blade to the ground and stop the engine. REMARK 6 - 3 2. Turn the starting switch to O N position (electricity flows in the electrical circuit), then turn th e accumulator switch ON. 3. Maintain the condition in Step 2, operate the left and right blade lift levers to the front and pressure inside the accumul rear, and bleed the remaining ator and hydraulic circuit. OFF, then start the engine. 4. Turn the accumulator switch 5. Maintain the condition in Ste p 4, and extend the left and right blade lift cylinders approx. 5 retaining pressure is genera cylinders.) 6.
Turn the accumulator switch 0 mm (2.0 in). (When doing this, ted at the bottom of the blade lift ON and start the accumulator. The oil at the bottom end of th will flow into the accumulator will retract, and the front whe ground. e left and right blade lift cylinders , the left and right blade cylinders els will come into contact with the In the condition Step 6, the pre ssure is maintained at the bottom end of th e blade lift cylin der so the blade p ushes at a certain pressure. If operations are carried out in the condition in Step 6, the blad e wil l be a ble to follow a rise or fall of appr ox.
50 mm (2.0 in) in the ground surf ace, so uniform accumulator operations ca n be carried o In actual fact, by operating th e blade lift cylinder lever in a suitable way, work is carrie d out within a cert ain up- down follow-up range with a s Once the accumulator is set , there is no need to operate the blade lift cy linder when s tarting operations. If the operation is stopped and the switch is turned OFF, raise the blade and p ut the blade in contact with the ground again, then turn the switch O N to make it possible to set the accumulato r to the same