. OPERATION EXPLANATION OF COMPONENTS RPM SET SWITCH Use this switch (16) when setting or adjusting the angle of the accelerator. 3 - 44 ADDITIONAL CAR HEATER S (If equipped Use this swit ch (15) to turn th e heater O N/OF F and to re gulate the air flow (2 st Position (A): ON, low air flow Position (B): Position (C): ON, high air flow Position (A) (push front): SET /ACCEL the accelerator pedal has If this switch is pushed forw ard when been depres sed to give the n ecessary engin e speed, th e opening angle of the accelerator at th at point i s maintained and r lights up.
the RPM SET pilot la mp on the machin e monito r lights Once the ac celerator opening angle ha s been set, if the fr ont of the switch is pu shed, the accele rator opening a approx. 7% each time the sw itch is pressed. If the front of the switch is k increase 50 % each second. Position (B) (push back): RE SUME/DECEL Once the ac celerator opening angle ha s been set, if the b ack of the switch is p ushed, the accelerator opening a ngle will decreas e by approx. 7% each time the s witch is pre If the back o f the switch is ke pt pushed , the opening an gle will decrease 50% each sec ond.
Once the ac celerator openin g angle h as be en set in th mode, if the back of th e switch is temporary c cancel. b ition before the