Removing and installing crankshaft Checking spread of bearing shells Fig. 5 Position bearing shells together on flat surface. Measure and note down spread dimensions “A” and “B”. B Spread dimension = A − B A 5 Installing crankshaft Fig. 6 Clean oil ducts in crankcase and in crankshaft with dry compressed air. Thoroughly clean bearing shells and bearing journals. Install bearing shells in crankcase, observing the numbering. 6 Fig. 7 Apply oil to the running surfaces on the bearing shells and install crankcase, ensuring that the markings on the crankshaft and camshaft gears coincide. Fig. 8 Check whether the bearing cap bolts have ex- ceeded the max.
permissible length (see “Engi- neering S Data S Setting values”). Bolts that have been removed may be reused if the max. permissi- ble length is not exceeded. 7 Insert bearing cap screws and tighten to specified torque in stages from the inside out (see “Engi- neering S Data S Setting values”). Tighten finally by angle. Check to see that crankshaft runs smoothly. Caution: Faulty bearing caps cannot be replaced singly. 8 114