You can fine tune the LEXION perfectly to any harvest. Hydraulic reel drive. Badly lodged crops and wide cutter bars place heavy demands on the reel. The new hydraulic drive from CLAAS gives it the extra torque and rapid control needed for good results. The cutter bar determines the combine’s output. Quick change from barley to The crop must enter the threshing sys- With additional cover plates across the tem in an even flow if you are to width of the cutter bar table, the VARIO achieve the highest output, lowest fuel cutter bar can be extended still further consumption and have a smooth run- without the need for any tools to har- ning machine. These are the basic vest OSR.
After being lengthened by parameters in achieving high overall 500 mm, the lateral knife set is fitted efficiency on a modern combine. and the LEXION 480 is ready to cut the rape harvesting. Consistent crop intake. The controlied multifinger tines across the full auger width plus the high auger flights feed the crop smoothly to the conveyor in all conditions, keeping the threshing drum fully employed all the time. rape. This is a time saving approach Push button flexibility. and makes it unnecessary to invest in The VARIO cutter bar was developed for an extra rape cutter bar. The optional situations where the table width needs CLAAS cutter bar trailer also has a to be adjusted on the go.
A shorter table compartment to store the filler plates width is useful in short barley, whilst it and lateral knives. should be wider in high yielding wheat and long stemmed rye,. The setting is changed at the touch of a button in the cab in a range from 100 mm shorter to 200 mm longer. This enables a consistently high crop flow to the threshing drum in all conceivable conditions, raising the combine’s performance and improving your operating economics. In case blockage. of The hydraulic reverser drives the feeder housing and the cutter bar or maize header, The hydraulic motor generates high torque for clearing blockages quickly.