Removing and installing timing case Removing timing case D Remove starter, see page 128 D Removing flywheel, see page 75 D If necessary removing air compressor, see page 132 D If necessary, remove the charge-air pipe be- tween the intake pipes, see Page 80 Fig. 1 Oil and coolant lines, brackets for cable harnesses etc are attached to the timing case; these items have to be removed. 1 Remove timing case cover. Fig. 2 Remove mounting bolts from timing case. The timing case is bolted to the oil pan at the bottom. Remove the mounting bolts from the oil pan. 2 Fig. 3 Danger: The timing case is heavy To facilitate assembly, two facing bolts may be in- serted by means of guide pins А (M12x1.5).
Two long M10 bolts Б screwed into the dead-end holes in the flange-on face facilitate handling the timing case. 1 1 2 Remove timing case. 3 Installing timing case Fig. 4 Clean contact face on crankcase of sealing resi- dues. Fit a new seal, sticking it on with a small amount of grease if necessary. Guide timing case on to the alignment pins and bolt it into place. Ensure that the oil pan gasket is in order, if necessary exchanging it. 4 108