MAN Nutzfahrzeuge Aktiengesellschaft — Removing and installing camshaft, exchanging camshaft bearings

Removing and installing camshaft, exchanging camshaft bearings Removing camshaft D Drain coolant, see page 46 D Remove oilpan, see page 65 D Remove starter, see page 128 D Remove flywheel and timing case, see page 75 D Remove the rocker arms and take out the push rods, see page 91 Note: For removing the camshaft the engine must be turned by 180 _ . For this reason the engine must be placed on a dolly. Fig. 1 Turn engine upside down so that the valve tappets do not obstruct removal of camshaft. Pull out camshaft; ensure that the camshaft bear- ings do not get damaged. Check camshaft for wear and damage, if necess- ary exchanging it.

If the camshaft or the drive gear is damaged, a new entire camshaft / gear unit must be fitted. 1 Fig. 2 Push push rods out of the guide using a suitable mandrel, check them for wear, if necessary ex- changing them. Push rods can be removed only if the camshaft is removed first. Exchanging camshaft bearings 2 Fig. 3 Knock out the camshaft bearing bushes using a suitable mandrel and knock in the new bushes until flush. Ensure that the position of oil supply bore (arrow) is correct. Note: The axial camshaft stop is located behind the last camshaft bearing bush on the timing case side. Owing to the helical gearing of the drive gear, the camshaft is always pulled against this stop. 3 110