MAN Nutzfahrzeuge Aktiengesellschaft — Removing and installing piston with connecting rod

Removing and installing piston with connecting rod Removing piston with connecting rod D Drain engine oil, see page 65 D Removing cylinder head, see page 91 Fig. 1 Remove bolts from connecting rod bearing cap. Fig. 2 Take off connecting rod bearing caps with bearing shells, expediting the procedure by means of light strokes with a synthetic hammer if necessary. 1 Note: Connecting rod bearing caps are match- marked with the connecting rod big ends; arrange them in corresponding order. Remove combustion residues (oil carbon) from top cylinder edge using a piece of hard wood. Caution: Do not damage cylinder liners. 2 Fig. 3 Push out connecting rod with piston in upward direction. Caution:

Do not damage oil spray nozzles. 3 Fig. 4 Lay pistons with connecting rods and associated caps aside; use deposit rack if available. Inspect pistons and piston rings visually. Note: For reworked crankcase sealing faces repair pistons with undersizes of 0.2, 0.4 and 0.6 mm in the compression height are available (see “Service Data”). 4 117