163 Torque guide values Tightening the cylinder-head bolts on a new engine ( Engine cold or warm) The cylinder heads are fitted with cylinder-head bolts for rotation angle tightening. On new en- Zweiter Nachzug der Zylinder- gines, the cylinder-head bolts are retightened at kopfschrauben erledigt the factory after running in and marked by the sticker “First retightening of cylinder-head bolts ...” on a cylinder head cover. Second retightening of cylinder- head-bolts completed Spare part no. 51.97801−0211 After the first 400 hours of operation, following a repair, tighten the cylinder-head bolts 1 to 4 in the order specified in the tightening schedule “1” by 90° (1/4 turn).
Intake side / injection nozzle The two outer bolts (intake and exhaust side) must not be retightened. 1 4 Note: The cylinder-head bolts to be retigh- tened must not be loosened; they are to be tightened further from their current position by 90° (1/4 turn). 3 2 MAN Exhaust side Remove the sticker “First retightening of the cylinder-head bolts ...” and attach the sticker Tightening schedule “1” “Second retightening of the cylinder-head bolts ...” to verify the second retightening. Zweiter Nachzug der Zylinder- kopfschrauben erledigt Second retightening of cylinder- head-bolts completed Spare part no. 51.97801−0212