Removing and installing coolant pump Installing coolant pump Fig. 3 Clean the sealing faces on coolant pump and en- gine housing. Fit coolant pump with new seal. Fit the mounting bolts. 3 Fig. 4 With water pumps with high-temperature and low-temperature sections To aid in assembly pins (special tool, see page 177, no. 43) can be screwed into the crankcase (arrows, Fig. 3). The water pump can then be fixed to the protruding pins. Fit mounting bolts. There is a screw for removing the pins (special tool, see page 177, no. 42). This screw has a left-handed thread and is screwed into the pin. In this way the two can be screwed out together. 4 Fit remaining mounting bolts. Fig.
5 Turn engine to ignition TDC, see page 29. Set delivery start indicator so that its measuring edge points exactly to the TDC point on the grad- uated scale. Tighten the mounting bolts to the specified torque. Screw coolant hose pipe on to oil cooler. Install short-circuit inserts / thermostats, see page 47. 5 Fit and tighten V-belts, see page 131. Filling up with coolant, see page 46 49