MAN Nutzfahrzeuge Aktiengesellschaft — Exchanging bearing race

Exchanging bearing race Exchanging bearing race Remove flywheel, see page 75. Fig. 1 If the shaft seal on the flywheel end is to be ex- changed, it is advisable to exchange the bearing race too. Pull off the bearing race to be exchanged using a puller (special tool, see Page 173). 1 Fig. 2 Insert the new bearing race into the pressing man- drel (special tool) so that for the subsequent as- sembly the internally chamfered side faces the fly- wheel. Carefully heat the pressing mandrel with the bear- ing race. The installation temperature for the bearing race is about 150 _ C. 2 Fig. 3 Press in bearing race until it stops. 3 Fig.

4 Seal the gap between the flywheel and the bearing race with “Antipor 46”. 4 78