Checking axial and radial clearance of turbocharger rotor shaft D Remove turbocharger, see page 87 D Mark turbine housing relative to the bearing housing D Remove turbine housing Axial clearance Fig. 1 Apply dial gauge holder and dial gauge under pre- load to shaft end face of the turbine wheel as shown. Press rotor shaft against dial gauge. Read and note down value. Push rotor in opposite direction. Read and note down value. The difference between the two is the axial play. Change turbocharger if axial clearance is ex- ceeded. 1 Radial clearance Radial clearance is measured only on turbine end with dial gauge or feeler gauge. Fig. 2 Dial gauge: Apply dial gauge tip to side of hub.
Push turbine wheel towards dial gauge. Read and note down value. Push turbine wheel in opposite direction. Read and note down value. The difference between the va- lues is the radial clearance. Measure at several points. If the play exceeds the permissible value, ex- change turbocharger. 2 D Fit turbine housing. Ensure that the markings coincide D Tighten turbine housing bolts to specified torque D Installing turbocharger 89