(3) TILT LEVER Adjust the tilt of the steering wheel by pulling the Tilt Lever toward the steering wheel and moving the wheel to the desired angle. Releasing the lever will lock the wheel in the desired location. (4) HORN AND TELESCOPING ADJUSTMENT The horn is activated by depressing the center "button". Operation of the horn should be verified before starting engine or moving truck. The steering wheel adjustment may be moved "in" or "out" (telescoped) by rotating the housing around the horn button counterclockwise to unlock the adjustment. After selecting the desired position, rotate the housing clockwise to lock the adjustment.
HAZARD FLASHER SWITCH Not shown in the illustration is the "HAZARD" flasher switch. It is located below the steering wheel, approximately in the "seven O’ clock" position. Pulling the switch out activates all turn signal lights, causing all lights to flash simultaneously. These should be used to mark the truck when necessary to park an inoperative truck at the side of the road or other unusual parking place. (5) HOIST CONTROL LEVER The hoist control lever is a three-position hand operated switch located to the left of the operator seat. A push button in the center of the control knob must be depressed to unlock the lever from the neutral position.
Pulling the lever up actuates the hoist circuit causing body to raise. Hold lever in hoist position until load is dumped. Releasing the lever from the hoist position will place the body in a hold position. To lower body, move the hoist lever to the "Down" position and release. Releasing the lever, places the hoist control valve in the "Float" position allowing the body to return to the frame. HB4-2 Operator Controls HB4021 6/95