Doosan — Doosan D60S-5 and G60S-5 Lift Truck Operation Manual

Operation Section Table 2. MI-07 Diagnostic Fault Codes (Flash Codes) cont’d. (*) Fault actions shown are default values specified by the OEM. 103 DFC PROBABLE FAULT FAULT ACTION * CORRECTIVE ACTION FIRST CHECK 772 GasPostO2FailedRich Pre-catalyst O2 sensor indicates extended rich operation on LPG (1) TurnOnMil (2) DisableGas PostO2Ctrl Correct other faults that may contribute to 772 (e.g. faults pertaining to FTVs, Pre-Cat O2, Post Cat O2 sensor) Look for leaks in exhaust, catalytic converter, HEGO sensors; repair leaks. Check all sensor connections (see fault 742 corrective actions).

843 Reserved 911 O2RangeLow Pre-catalyst O2 sensor voltage out of range low, sensor signal shorted to ground (1) TurnOnMil (2) DisableGas O2Ctrl Check if O2 sensor installed before the catalyst is shorted to GND or sensor GND. O2 (signal) Pin 3 to SECM Pin B13 SECM (DRVG GND) Pins A16, B17 SECM (XDRG sensor GND) Pin B1 912 O2 PostCatRangeLow _ Post-catalyst O2 sensor voltage out of range low, sensor signal shorted to ground (1) TurnOnMil (2) Disable LPG Post-catalyst O2Ctrl Check if O2 installed after the catalyst sensor is shorted to GND or sensor GND. O2 (signal) Pin 3 to SECM Pin B19 Possible sources:

SECM (DRVG GND) Pins A16, B17 and SECM (XDRG sensor GND) Pin B1 921 O2RangeHigh Pre-catalyst O2 sensor voltage out of range high, sensor signal shorted to power (1) TurnOnMil (2) DisableGas O2Ctrl Check if O2 sensor installed before catalyst is shorted to +5Vdc or battery. O2 (signal) Pin 3 to SECM Pin B13 SECM (XDRP + 5V) Pin B24 SECM (DRVP + 12V) Pin A23 922 O2 PostCatRangeHigh _ Post-catalyst O2 sensor voltage out of range low, sensor signal shorted to ground (1) TurnOnMil (2) Disable LPG Post-catalyst O2Ctrl Check if O2 sensor installed after catalyst is shorted to +5Vdc or battery. O2 (signal) Pin 3 to SECM Pin B19 Possible voltage sources:

SECM (XDRP + 5V) Pin B24 and SECM (DRVP + 12V) Pin A23