Operation Section Lift Truck Operation Power Shift Transmission / Drive Axle A lift truck with the engine running but without an operator can move slowly (creep) if the transmission is left engaged. This could result in personal injury. Always place the transmission control levers in the NEUTRAL (center) position and apply the parking brake before dismounting from the lift truck. 1. Start the engine. See item "Starting the Engine" 6. RELEASE the service foot brake. 7. PUSH DOWN on the accelerator pedal to obtain the desired travel speed. RELEASE the pedal to decrease travel speed. 8.
Transmission speed changes to second and third speed range can be made on the go, without deceleration or braking. When faster travel speed is needed. Typical Example 2. PUSH DOWN on the service foot brake pedal to hold the lift truck until ready to move it. 3. RELEASE the parking brake. NOTICE Come to a complete stop before changing direction of travel. Sudden reversal of a loaded lift truck traveling forward can cause the load to fail or the lift truck to tip over. Stop the loaded lift truck completely, before shifting to reverse. Failure to comply could result in personal injury. Typical Example 9. To change the lift truck direction of travel, RELEASE the accelerator pedal. 10.
PUSH DOWN on the service foot brake pedal to bring the lift truck to a complete stop. 11. SHIFT the directional lever to the desired direction of travel. Rotate the speed selector lever to first (low) speed range, if it is not already in this position. 12. RELEASE the service foot brake. PUSH DOWN on the accelerator pedal to obtain the desired travel speed. 4. Select the direction of travel by PUSHING the directional lever FORWARD for forward direction or PULLING the lever BACK for reverse direction. 5. Rotate the speed range control to first (low) speed range. NOTE: From a stopped position, move the lift truck in first (low) range ONLY. 105 WARNING WARNING