Operation Section • Direction Inhibit Point (SW2) Diagnostics Features Auto Shift allows you to set the Direction Inhibit Speed, the maximum travel speed at which the transmission can be reversed. For adjustment of direction inhibit speed, the SW2 switch is used on the printed circuit board. Using a philips screwdriver, turn the SW1 adjustment until the white dot is next to the notch corresponding to the selected vehicle speed. You may reset lnhibit Speed to one of ten settings between a minimum of 3.3km/h(2.05mph) and a maximum of 6.0km/h(3.75mph) travel speed. ASC-200/201 has internal indicator on the right side of the controller for displaying the selected gear and the abnormal condition.
Do not diagnose or repair Auto Shift Controller Faults unless trained and authorized to do so. Improper performance of maintenance procedures is dangerous and could result in personal injury or death. For example if SW2 is put 7 th notch, the Direction lnhibit Speed will be 5.4km/h(3.36mph) which is factory setting value as a default. Below is a description applicable for many ASC-200/201 implementations. • Display for Operator NOTICE This information is given during normal operating when something special happens. For example, on ASC-200/201's with the speed sensor, one of the indicators is used to indicate a sensor problem.
The transmission of your lift truck may be reversed under full power up to a travel of 6.0 km/h (3.73 mph). But the Inhibit Speed of Auto Shift is set by the factory at 4~5 km/h (2.5~3.2 mph) because reversing the transmission at lower travel speeds prolongs the lift of the transmission, axle shafts and tires.
108 SW2(FWD RVS SHIFT) Direction lnhibit Point Notch Vehicle Speed 0 3.3km/h (2.05mph) 1 3.6km/h (2.24mph) 2 3.9km/h (2.42mph) 3 4.2km/h (2.61mph) 4 4.5km/h (2.80mph) 5 4.8km/h (2.98mph) 6 5.1km/h (3.17mph) 7 5.4km/h (3.36mph) 8 5.7km/h (3.54mph) 9 6.0km/h (3.73mph) WARNING Display Description Remark A Automatic operation H High speed At 2nd shift gear L Low speed At 1st shift gear PT/M Speed sensor open Flashing E E/G Speed sensor open Flashing F Controller fault Flashing 5 H/L Sol. Short Flashing 6 Forward Sol. Short Flashing 7 Reverse Sol. Short Flashing Product Notch Adaptable ASC-200 7 5.4km/h(3.36mph) ASC-201 3 4.2km/h(2.61mph)