Doosan — Doosan D60S-5 and G60S-5 Lift Truck Operation Manual

Operation Section Typical Example of ASC-200 NOTE: In ASC-200 factory-setting controller, automatic mode is selected for both direction inhibit and two-speed auto shift control as a default on the PCB(Printed Circuit Board).In ASC-201 factory-setting controller, manual mode(Fail-Safe Mode) is selected as a default for direction inhibit while automatic mode is selected as a default for two-speed auto shift control. 7. Replace the Controller cover plate and screws. 8. Turn ON the electrical disconnect switch, if equipped. 9. Start engine. check the Controller LED indication for "A". For indications other than "A", see following section on Fault Diagnosis. NOTE:

After operating the truck manually by selecting the Manual Mode switch on PCB(Printed Circuit Board), the position of mode must be checked before operating the truck automatically. 111