Doosan — Doosan D60S-5 and G60S-5 Lift Truck Operation Manual

Maintenance Section Causes of Fork Failure Improper Modification or Repair z Wear Forks are constantly subjected to abrasion as they slide on floors and loads. The thickness of the fork blade is gradually reduced to the point where it may not be capable of handling the load for which it was designed. Fork failure can occur as a result of a field modification involving welding, flame cutting or other similar processes which affect the heat treatment and reduces the strength of the fork. In most cases, specific processes and techniques are also required to achieve proper welding of the particular alloy steels involved.

Critical areas most likely to be affected by improper processing are the heel section, the mounting components and the fork tip. Bent or Twisted Forks z Stress Risers Scratches, nicks and corrosion are points of high stress concentration where cracks can develop. These cracks can progress under repetitive loading in a typical mode of fatigue failure. Overloading Forks can be bent out of shape by extreme overloading, glancing blows against walls or other solid objects or using the fork tip as a pry bar. Bent or twisted forks are much more likely to break and cause damage or injury. They should be removed from service immediately.

Fatigue Extreme overloading can cause permanent bending or immediate failure of the forks. Using forks of less capacity than the load or lift truck when lifting loads and using forks in a manner for which they were not designed are some common causes of overloading. Parts which are subjected to repeated or fluctuating loads can fail after a large number of loading cycles even though the maximum stress was below the static strength of the part. The first sign of a fatigue failure is usually a crack which starts in an area of high stress concentration This is usually in the heel section or on the fork mounting.

As the crack progresses under repetitive load cycling, the load bearing cross section of the remaining metal is decreased in size until it becomes insufficient to support the load and complete failure occurs. Fatigue failure is the most common mode of fork failure. It is also one which can be anticipated and prevented by recognizing the conditions which lead up to the failure and by removing the fork service prior to failing. z Repetitive Overloading Repetitive cycling of loads which exceeds the fatigue strength of the material can lead to fatigue failure. The overload could be caused by loads in excess of the rated fork capacity and by use of the forks tips as pry bars.

Also, by handling loads in a manner which causes the fork tips to spread and the forks to twist laterally about their mountings. 122