Doosan — Doosan D60S-5 and G60S-5 Lift Truck Operation Manual

Maintenance Section Any API classification performance of oil should have sufficient TBN for fuels with less than 0.5% sulfur. For fuels with 0.5% to 1.5% sulfur by weight, engine oil must have a TBN of 20 times the percentage of fuel sulfur as measured by the ASTM (American Society of Testing Materials) D-2896 method. (ASTM D-2896 can normally be found at your local technological society, library or college). DOOSAN recommends infrared analysis (in conjunction with wear metal analysis) of used oil in determining the effectiveness of oil TBN and acid neutralization. For fuel with sulfur exceeding 1.5% by weight, use an oil with a TBN of 30 and reduce the oil change interval by one half.

Also, infrared analysis and wear metal analysis should be used to establish oil change intervals. Periodically request fuel sulfur content information from your fuel supplier. Fuel sulfur content can change with each bulk delivery. LP Specifications LP is "liquefied petroleum gas". The exact composition of LP varies slightly between different parts of the country and different refineries. HD5 is recommended for DOOSAN forklift trucks. Remember LP is heavier than air and will sink to the lowest spot possible. Avoid areas near floor drains or lubrication pits where escaped fuel may collect.

131 Composition of HD5 Propane (C3H9) Propylene Butane (C4H10) iso-Butane Methane (CH4) 90.0 % up to 5 % 2.0 % 1.5 % 1.5 % Total 100 %