Maintenance Section When Required You must read and understand the warnings and instructions contained in the Safety section of this manual, before performing any operation or maintenance procedures. Engine Valve Lash (Diesel E/G Only) - Check, Adjust Priming the Fuel System (Diesel Engine Only) Bleeding the Fuel System The valve clearances are to be adjusted at the times of the following situations. NOTICE After changing the fuel filter, or after having serviced any part of the fuel system, make sure that the air is bled from the system. 1. Release the feed pump cap (1) on the injection pump. 2. Release an air bleed nut (2) on the injection pump. 3.
Operate feed pump vertical until completely remove an air. 4. Tighten air bleed nut (2). 5. Make sure to check leakage of injection pump & filter after operating feed pump many times. z When the engine is overhauled and the cylinder heads are disassembled. z When severe noise comes from valve train. z When the engine is not normally operated even though there is no trouble in the fuel system. To prevent possible injury when adjusting diesel engines, Do not use the starter motor to turn the flywheel. Hot engine components can cause burns. Allow additional time for the engine to cool before measuring valve clearance. Measure the valve lash with the engine stopped.
To obtain an accurate measurement, allow at least 20 minutes for the engine cylinder head and block to cool. NOTICE Set the clearance to the nominal appropriate clearance given in the "Valve Clearance Setting" chart shown below. Refer to the "Service Manual" for the complete valve adjustment procedure. NOTE: In case of LP Engine, no valve adjustment is necessary. 140 WARNING Valve Clearances Engine Valve Clearance 5.8 Liter (DB58S) Diesel Exhaust Valves .40 mm (.16 in) Intake Valves .40 mm (.16 in)