Doosan — Doosan D60S-5 and G60S-5 Lift Truck Operation Manual

Maintenance Section Fuses, Bulbs & Circuit Breaker - Change, Reset Fuses Fuse & Relay ( LP Engine Only) NOTE: If a fuse filament separates, use only the same type and size fuses for replacement. If the filament in a new fuse separates. have the circuits and instruments checked. Always replace fuses with ones of the correct ampere rating. NOTICE (1)Relay (2)Fuse Remove the front cover of fuse box. The fuses are located under the cover. Located on top of engine Fuse - Protects an electrical circuit from an overload. Opens (filament separates) if an overload occurs. 1. Raise the floor mat. Circuit Breaker Typical Example LP Engine Truck 2.

The main circuit breaker is located on the rear of the support for the controls. NOTE: To reset circuit breakers push on the button. The button should stay in if the breaker is reset. If the button will not stay in, or comes out shortly after reset, have the circuits checked. Typical Example Check the fuses. Use a flashlight, if necessary. Fuses are identified as follows : 1. Horn - 10 amp. 2. Head Lamp - 15 amp 3. Fwd./Rev. Solenoid, lamp Relay & Back-up Lamp/alarm - 10 amp. 4. Instrument Panel & Fuel Shutoff - 15 amp. 5. Turn Signal Lamp, Stop/Strobe Lamp - 15 amp 6. Start Relay - 10 amp 143