Maintenance Section Radiator Cap - Clean, Change Clean Outside of Radiator Core Clean Pressure Cap Pressure air can cause personal injury. When using pressure air for cleaning, wear a protective face shield, protective clothing and protective shoes. The maximum air pressure must be below 205 kPa (30 psi) for cleaning purposes. Compressed air, high pressure water or steam can be used to remove dust, leaves and general debris from a radiator. Clean as required by condition of radiator. The use of compressed air is preferred. Carriage Roller Extrusion - Adjust 1. Set the mast vertical. 2. Lower the carriage completely. 3.
On full free lift and full free triple lift models, the bottom of the inner mast must be flush with the bottom of the stationary mast. The radiator cap is located on the left side of the lift truck. (Diesel Engine Truck) The radiator cap is located on the right side of the lift truck. (LP Engine Truck) Hot oil and components can cause personal injury. Do not allow hot oil or components to contact skin. WARNING 4. Measure the distance from the bottom of the inner upright to the bottom of carriage bearing. 5. The measurement (A) must be as follows in Chart below. 1. Remove the radiator cap slowly to relieve pressure. 2. Inspect the cap for damage, deposits or foreign material.
Clean the cap with a clean cloth or change the cap as necessary. 3. Install the cap. 145 WARNING Height of carriage roller extrusion (A) STD mast FF mast FFT mast D50/60/70S-5 (3 Speed, 2 Speed), G50/60/70S-5 23 - 26 D80/90S-5(3 Speed) 42 - 42