Doosan — Doosan D60S-5 and G60S-5 Lift Truck Operation Manual

Maintenance Section 13. When the oil temperature is around 40 ° C, the marking on the oil dipstick must be lying above the cold start mark, "COLD". When the oil temperature is around 80 ° C, the oil level must be lying in the zone "HOT". 14. Install the oil dipstick again and tighten it clockwise. 15. Check for oil leaks at the filter and drain plug. 16. Stop the engine. Drive Axle Oil - Change Park the lift truck on a level surface, parking brake applied, transmission in neutral. Hot oil and components can cause personal injury. Do not allow hot oil or components to contact skin. Shoe Brake Type Typical Example 1.

Raise the carriage high enough to access the drive axle housing level/fill plug with breather. 2. Block the bottom of the carriage with a block of wood to hold the carriage in the raised position. 3. Turn the ignition switch OFF. 4. Remove the drive axle housing level/fill plug with breather. Wash them in clean, nonflammable solvent. 5. Place an appropriate container under the axle to catch the oil as it drains. Remove the drive axle housing drain plug. 6. Allow the oil to drain completely out. Discard the old oil according to local regulations. 7. Clean and reinstall the drive axle housing drain plug. 155 WARNING