RAM ProMaster City — Electronic Stability Control (ESC) OFF Warning Light — If Equipped

50 GETTING TO KNOW YOUR INSTRUMENT PANEL position before engine start. After placing the ignition to the ON/RUN position, if there is a problem with the Sentry Key System, the Vehicle Security Light will turn on. This condition will result in the engine being shut off after two seconds. If the bulb does not come on when turning the ignition switch from OFF to ON/RUN, have the condition checked promptly. WARNING! in the ESC system. If this light remains on after several ignition cycles, and the vehicle has been driven several miles (kilometers) at speeds greater than 30 mph (48 km/h), see an authorized dealer as soon as possible to have the problem diagnosed and corrected.

A malfunctioning catalytic converter, as refer- enced above, can reach higher temperatures than in normal operating conditions. This can cause a fire if you drive slowly or park over flam- mable substances such as dry plants, wood, cardboard, etc. This could result in death or seri- ous injury to the driver, occupants or others. The ESC OFF Indicator Light and the ESC Indi- cator Light come on momentarily each time the ignition is placed in the ON/RUN or MAR/ON/ RUN position. NOTE: This warning light will illuminate when the vehicle security system has detected an attempt to break into the vehicle.

Certain conditions, such as a loose or missing gas cap, poor quality fuel, etc., may illuminate the light after engine start. The vehicle should be serviced if the light stays on through several typical driving styles. In most situations, the vehicle will drive normally and will not require towing. CAUTION! Each time the ignition is turned to ON/RUN or MAR/ON/RUN, the ESC system will be on, even if it was turned off previously. Prolonged driving with the Malfunction Indicator Light (MIL) on could cause damage to the vehi- cle control system. It also could affect fuel econ- omy and driveability. If the MIL is flashing, severe catalytic converter damage and power loss will soon occur.

Immediate service is required. The ESC system will make buzzing or clicking sounds when it is active. This is normal; the sounds will stop when ESC becomes inactive. This light will come on when the vehicle is in an ESC event. Electronic Stability Control (ESC) OFF Warning Light — If Equipped When the engine is running, the MIL may flash to alert serious conditions that could lead to immediate loss of power or severe catalytic converter damage. The vehicle should be serviced by an authorized dealer as soon as possible if this occurs.

Electronic Stability Control (ESC) Warning Light — If Equipped The ESC Indicator Light in the instrument cluster will come on when the ignition is placed in the ON/RUN or MAR/ON/RUN position, and when ESC is activated. It should go out with the engine running. If the ESC Indicator Light comes on continuously with the engine running, a malfunction has been detected Each time the ignition is turned to ON/ RUN or ACC/ON/RUN, the ESC system will be on, even if it was turned off previously. This warning light indicates the ESC is off.