STARTING AND OPERATING 67 CAUTION! WARNING! To avoid vehicle damage, the vehicle must be driven slowly when using ParkView to be able to stop in time when an obstacle is seen. It is recommended that the driver look frequently over his/her shoulder when using ParkView. Never have any smoking materials lit in or near the vehicle when the gas cap is removed or the tank is being filled. Never add fuel when the engine is running. This is in violation of most state and federal fire regulations and may cause the Malfunc- tion Indicator Light (MIL) to turn on. NOTE: If snow, ice, mud, or any foreign substance builds up on the camera lens, clean the lens, rinse with water, and dry with a soft cloth.
Do not cover the lens. REFUELING THE VEHICLE Fuel Filler Cap A fire may result if gasoline is pumped into a portable container that is inside of a vehicle. You could be burned. Always place gas containers on the ground while filling. 4 NOTE: The driver's side sliding door cannot be opened while the fuel door is open. This feature operates only when the sliding door is in a closed position prior to opening the fuel door. 3. Fully insert the gasoline nozzle into the filler pipe. The gas cap is located on the left side of the vehicle. If the gas cap is lost or damaged, be sure to use the correct replacement cap for this vehicle. CAUTION! 1. Open the fuel filler door. 4.
Fill the vehicle with fuel. Damage to the fuel system or emissions control system could result from using an improper fuel tank filler tube cap. A poorly fitting cap could let impurities into the fuel system and may cause the Malfunction Indi- cator Light (MIL) to turn on, due to fuel vapors escaping from the system. 2. Remove the fuel cap by rotating it counter- clockwise. NOTE: When the fuel nozzle “clicks” or shuts off, the fuel tank is full. 5. Remove gasoline nozzle, reinstall fuel cap and close fuel filler door. To avoid fuel spillage and overfilling, do not “top off” the fuel tank after filling.