Komatsu — CLSS

STRUCTURE AND FUNCTION CLSS 4. OPERATION OF SYSTEM AS A WHOLE 1) When all control valves are at neutral Pump discharge amount Q all flows from un- load valve (6) to tank (1). Non of the spools (7A to 12A) are being opereted, so the LS pressure P LS is not generated. At the same time, the LS pressure P LS is connected to the tank circuit by LS by- pass plug (5), so it is the tank pressure. In this condition, LS differential pressure PLS becomes the unload pressure - tank pressure, and becomes higher than the LS set pressure of LS valve (4), so main pump (2) is set to the minimum swash plate angle. 12. Swing valve 12A. Spool 12B. Pressure compensation valve (LEFT) 12C.

Pressure compensation valve (RIGHT) 13. LS select valve 14. LS bypass plug 15. Main relief valve 16. Cooler bypass valve 17. Lift check valve Actuator 18. Bucket cylinder 19. Arm cylinder 20. Boom cylinder 21. Travel motor 22. Dozer cylinder 23. Swing motor 1. Hydraulic tank # The safety-suction valve, and suction valve are not shown. Hydraulic pump 2. Main pump 3. PC valve 4. LS valve Control valve 5. LS bypass plug 6. Unload valve 7. Bucket valve 7A. Spool 7B. Pressure compensation valve (DUMP) 7C. Pressure compensation valve (CURL) 7D. LS shuttle valve 8. Arm valve 8A. Spool 8B. Pressure compensation valve (OUT) 8C. Pressure compensation valve (IN) 8D. LS shuttle valve 9. Boom valve 9A.

Spool 9B. Pressure compensation valve (RAISE) 9C. Pressure compensation valve (LOWER) 9D. LS shuttle valve 9E. Check valve 10. Travel valve 10A. Spool 10B. Pressure compensation valve (FORWARD) 10C. Pressure compensation valve (REVERSE) 10D. LS shuttle valve 11. Stabilizer valve 11A. Spool 11B. Pressure compensation valve (EXTEND) 11C. Pressure compensation valve (RETRACT) 11D. LS shuttle valve 10-88