Komatsu — CLSS

STRUCTURE AND FUNCTION CLSS 2) When boom RAISE is operated independ- ently When boom spool (A9) is operated to the RAISE position, pump discharge amount Q flows to the bottom end of boom cylinder (20), and at the same time, LS pressure P LS is gener- ated and unload valve (6) closes. LS pressure P LS becomes the boom holding pressure, and the area of the opening of boom spool (A9) is larger than the other spools (over- size opening), so the difference between pump discharge pressure Pp and LS pressure P LS (LS differential pressure P LS ) becomes smaller.

This LS differential pressure P LS is lower than the LS set pressure of LS valve (4), so main pump (2) is held at the maximum swash plate angle. 11. Stabilizer valve 11A. Spool 11B. Pressure compensation valve (EXTEND) 11C. Pressure compensation valve (RETRACT) 11D. LS shuttle valve 12. Swing valve 12A. Spool 12B. Pressure compensation valve (LEFT) 12C. Pressure compensation valve (RIGHT) 13. LS select valve 14. LS bypass plug 15. Main relief valve 16. Cooler bypass valve 17. Lift check valve Actuator 18. Bucket cylinder 19. Arm cylinder 20. Boom cylinder 21. Travel motor 22. Dozer cylinder 23. Swing motor 1. Hydraulic tank Hydraulic pump 2. Main pump 3. PC valve 4.

LS valve # The safety-suction valve, and suction valve are not shown. Control valve 5. LS bypass plug 6. Unload valve 7. Bucket valve 7A. Spool 7B. Pressure compensation valve (DUMP) 7C. Pressure compensation valve (CURL) 7D. LS shuttle valve 8. Arm valve 8A. Spool 8B. Pressure compensation valve (OUT) 8C. Pressure compensation valve (IN) 8D. LS shuttle valve 9. Boom valve 9A. Spool 9B. Pressure compensation valve (RAISE) 9C. Pressure compensation valve (LOWER) 9D. LS shuttle valve 9E. Check valve 10. Travel valve 10A. Spool 10B. Pressure compensation valve (FORWARD) 10C. Pressure compensation valve (REVERSE) 10D. LS shuttle valve 10-90