STRUCTURE AND FUNCTION CLSS 5) When circuit is relieved at end of boom stroke When boom cylinder (20) reaches the end of its stroke, main relief valve (15) opens and pump discharge amount Q is relieved to tank (1). When pump discharge pressure P P comes close to the relief pressure, the pump controller sends a signal to the solenoid of PC valve (3) to carry out the cut-off function to make pump dis- charge amount Q the minimum. The cylinder is at the end of its stroke, so no oil flows to the upstream or downstream side of boom spool (9A). Pump discharge pressure P P and LS pressure P LS are the same pressure, and LS differential pressure L P LS becomes 0.
LS differential pressure L P LS is lower than the LS set pressure of LS valve (4), so LS valve (4) acts to make the pump swash plate angle the maximum. However, because of the mecha- nism, the operation of PC valve (3) is given pri- ority over the operation of LS valve (4), so the pump is kept at the minimum swash plate angle by the cut-of function of PC valve (3). 11. Stabilizer valve 11A. Spool 11B. Pressure compensation valve (EXTEND) 11C. Pressure compensation valve (RETRACT) 11D. LS shuttle valve 12. Swing valve 12A. Spool 12B. Pressure compensation valve (LEFT) 12C. Pressure compensation valve (RIGHT) 13. LS select valve 14. LS bypass plug 15. Main relief valve 16.
Cooler bypass valve 17. Lift check valve Actuator 18. Bucket cylinder 19. Arm cylinder 20. Boom cylinder 21. Travel motor 22. Dozer cylinder 23. Swing motor 1. Hydraulic tank Hydraulic pump 2. Main pump 3. PC valve 4. LS valve # The safety-suction valve, and suction valve are not shown. Control valve 5. LS bypass plug 6. Unload valve 7. Bucket valve 7A. Spool 7B. Pressure compensation valve (DUMP) 7C. Pressure compensation valve (CURL) 7D. LS shuttle valve 8. Arm valve 8A. Spool 8B. Pressure compensation valve (OUT) 8C. Pressure compensation valve (IN) 8D. LS shuttle valve 9. Boom valve 9A. Spool 9B. Pressure compensation valve (RAISE) 9C. Pressure compensation valve (LOWER) 9D.
LS shuttle valve 9E. Check valve 10. Travel valve 10A. Spool 10B. Pressure compensation valve (FORWARD) 10C. Pressure compensation valve (REVERSE) 10D. LS shuttle valve 10-96