TESTING AND ADJUSTING TESTING LOCATIONS CAUSING HYDRAULIC DRIFT OF WORK EQUIPMENT TESTING LOCATIONS CAUSING HYDRAULIC DRIFT OF WORK EQUIPMENT # If there is any hydraulic drift in the work equipment (cylinders), check as follows to determine if the cause is in the cylinder packing or in the control valve. 1. Checking for defective cylinder packing # For machine equipped with accumulator 1) Checking boom and bucket cylinders i) Set in the same posture as when measuring hydraulic drift, and stop the engine. ii) Operate the boom control lever to RAISE or the bucket control lever to CURL. - if the lowering speed increases, the packing is defective.
- If there is no change, the boom holding valve (boom) or the control valve (bucket) is defective. 2) Checking arm cylinder i) Operate the arm cylinder to move the arm in fully, then stop the engine. ii) Operate the control lever to arm IN. - if the lowering speed increases, the packing is defective. - If there is no change, the control valve is defective. # If the pressure in the accumulator has dropped, run the engine for approx. 10 seconds to charge the accumulator again before operating. [Reference] If the cause of the hydraulic drift is in the packing, and the above operation is carried out, the downward movement becomes faster for the following reasons.
1) If the work equipment is set to the above posture (holding pressure applied to the bottom end), the oil at the bottom end leaks to the head end. How- ever, the volume at the head end is smaller than the volume at the bottom end by the volume of the rod, so the internal pressure at the head end in- creases because of the oil flowing in from the bot- tom end. 2) When the internal pressure at the head end in- creases, the pressure at the bottom end also rises in proportion to this. The balance is main- tained at a certain pressure (this differs according to the amount of leakage) by repeating this proce- dure. 3) When the pressure is balanced, the down- ward movement becomes slower.
If the lever is then operated according to the procedure given above, the circuit at the head end is opened to the drain circuit (the bottom end is closed by the check vale), so the oil at the head end flows to the drain circuit and the downward movement becomes faster. 20-43