TROUBLESHOOTING SEQUENSE OF EVENTS IN TROUBLESHOOTING SEQUENSE OF EVENTS IN TROUBLESHOOTING 20-55 Step 1 Examination, confirmation of symptoms 1) When a request for repairs is received, first ask the following points. • Name of customer • Type, serial numer of machine • Details of jobsite, etc. 2) Ask questions to gain an outline of the problem. • Condition of failure • Work being carried out at the time of the failure • Operating environment • Past history, details of mainte- nance, etc. Step 2 Determining probable location of cause 1) Look at the troubleshooting section of the shop manual to find locations of possible causes.
Step 3 Preparation of troubleshooting tools 1) Look at the table of troubleshooting tools in the shop manual and prepare the necessary tools. • T - adapter • Hydraulic pressure gauge kit. etc. 2) Look in the parts book and prepare the necessary replacement parts. Step 4 Go to jobsite Step 7 • Pinpoint locations of failure (carry out troubleshooting) • Decide action to take 1) Before starting troubleshooting, locate and repair simple failures. • Check before starting items • Other check items 2) See the Troubleshooting Section of the shop manual, select a troubleshooting flowchart that matches the symptoms, and carry out troubleshooting.
Step 6 Re-enacting failure • Drive and operate the machine to con- firm the condition and judge if there is really a failure. Step 5 Ask operator questions to confirm details of failure • Was there anything strange about the machine before the failure occurred? • Did the failure occur suddenly? • Had any repairs been carried out before the failure?