TROUBLESHOOTING POINTS TO REMEMBER WHEN CARRYING OUT MAINTENANCE Disconnection in wiring If the wiring is held and the connectors are pulled apart, or components are lifted with a crane with the wiring still connected, or a heavy object hits the wir- ing, the crimping of the connector may separate, or the soldering may be damaged, or the wiring may be broken. High-pressure water entering connector The connector is designed to make it difficult for water to enter (drip-proof structure), but if high-pressure water is sprayed directly on the connector, water may enter the connector, depending on the direction of the water jet.
As already said, the connector is designed to prevent water from entering, but at the same time, if water does enter, it is difficult for it to be drained. Therefore, if water should get into the connector, the pins will be short-circuited by the water, so if any water gets in, immediately dry the connector or take other appropri- ate action before passing electricity through it. Oil or dirt stuck to connector If oil or grease are stuck to the connector and an oil film is formed on the mating surface between the male and female pins, the oil will not let the electricity pass, so there will be defective contact.
If there is oil or grease stuck to the connector, wipe it off with a dry cloth or blow it dry with compressed air and spray it with a contact restorer. # When wiping the mating portion of the connector, be careful not to use excessive force or deform the pins. # If there is oil or water in the compressed air, the contacts will become even dirtier, so remove the oil and water from the compressed air completely before cleaning with compressed air. 20-57