Komatsu — POINTS TO REMEMBER WHEN CARRYING OUT MAINTENANCE

TROUBLESHOOTING POINTS TO REMEMBER WHEN CARRYING OUT MAINTENANCE 3. POINTS TO REMEMBER WHEN HAND- LING HYDRAULIC EQUIPMENT With the increase in pressure and precision of hydraulic equipment, the most common cause of failure is dirt (for- eign material) in the hydraulic circuit. When adding hydrau- lic oil, or when disassembling or assembling hydraulic equipment, it is necessary to be particularly careful. 1) Be careful of the operating environment Avoid adding hydraulic oil, replacing filters, or repair- ing the machine in rain or high winds, or places where there is a lot of dust.

2) Disassembly and maintenance work in the field If disassembly or maintenance work is carried out on hydraulic equipment in the field, there is danger of dust entering the equipment. It is also difficult to con- firm the performance after repairs, so it is desirable to use unit exchange. Disassembly and maintenance of hydraulic equipment should be carried out in a spe- cially prepared dustproof workshop, and the perform- ance should be confirmed with special test equip- ment. 3) Sealing openings After any piping or equipment is removed, the open- ings should be sealed with caps, tapes, or vinyl bags to prevent any dirt or dust from entering.

If the opening is left open or is blocked with a rag, there is danger of dirt entering of the surrounding area being made dirty by leaking oil so never do this. Do not simply drain oil out on to the ground, collect is and ask the customer to dispose of it, or take it back with you for disposal. 4) Do not let any dirt or dust get in during refilling operations Be careful not to let any dirt or dust get in when refilling with hydraulic oil. Always keep the oil filler and the area around it clean, and also use clean pumps and oil containers. If an oil cleaning device is used, it is possi- ble to filter out the dirt that has collected during stor- age, so this is an even more effective method.

20-62