TROUBLESHOOTING N-1 N-1 Communications abnormality # This troubleshooting is carried out when there is still an abnormality, so when disconnecting the connector and inserting the T-adapter, or when removing the T-adapter and returning the connector to its original position, if the service code "E" is not displayed, the problem has been removed. # If the starting switch was turned off after the abnormality occurred, turn the starting switch on and check that the service code displays E. (If it is not displayed, the problem has been removed.) # Before carrying out troubleshooting, check that all the related connectors are properly inserted.
# Always connect any disconnected connectors before going on to the next step. Table 1 When the controllers are not connected to the network, "..." is displayed. If the correct alphanumerics are not displayed (or another model is displayed), the controllers show ab- normal model selection. 20-104 YES 1 4YES Is monitoring code 02,03 display normal? Is resistance between YES P01 (4) (11) and chas- 3 sis or P01 (4) (11) • Disconnect C17 and P01 (14) normal? When C17 is discon- • Turn starting switch YES nected, do bits (1) • Disconnect connectorNO On. and (2) light up in C17, P01, and install • See Table 1. 2 monitoring code 087 T-adapter to P01. • Min.
1 Do bitts (1) and (2) • Disconnect light up in monitoring connector C17. NO NO code 08? • Turn starting switch ON. • See Table 2. YES • Turn starting switch 5 ON. Is voltage between C17 (4) (12) and NO chassis normal? 6YES Is resistance between • Turn starting P01(4), (11) and C17 switch ON. NO (4), (12) normal? • Min. 7.5 V • Disconnect C17 and measure • Disconnect P01, NO voltage at C17. harnees end. • Max.
1 Cause Remedy Has been reset Defective monitor panel Disconnection is between P01(4) (11) and P01 (14) or chassis Defective governor, pump controller Defective governor, pump controller Defevtive monitor panel Disconnection in wiring harnees between P01(4), (11) and C17 (4), (12) Replace Repair Replace Replace Replace Replace Replace Monitoring code Display 01 Monitor panel mode code 150 02 Engine throttle, pump controller model code 130 03 Engine throttle, pump controller model code 130