TROUBLESHOOTING E-11 E-11 Engine does not stop Check with the engine stopped (push the fuel control lever of the fuel injection pump to the NO INJECTION position). # Before carrying out troubleshooting, check that all the related connectors are properly inserted. # Always connect any disconnected connectors before goning on the next step. # Read the precautions given in TESTING AND ADJUSTING, "Adjusting travel of governor motor lever" before carrying out the troubleshooting. YES 2 YES Does governor lever contact STOP stopper, and does engine stop? YES Turn starting switch ON OFF. 3 Potentiometer 6 YES When linkage is adjusted, does condition become normal? Does loose spring move freely?
YES When starting switch is OFF, is voltage between C03 (14) and (17) normal? 1 NO Relay drive signal 5 When starting switch is OFF, does voltage between C01 (1) and (6) (12) change as shown in Table 2? Is controller model code as shown in Table 1? See TESTING AND ADJUSTING. Starting motor signal 4 YES When engine is stopped 2.9 - 3.3V NO When stating switch is OFF, is voltage between C03 (8) and chassis normal? 20 - 30V Turn starting switch ON. Set to monitoring code 03 or 02. NO NO Max.1V NO Table 1 NO # The diagram shows monitoring code 03. Table 2 Note 1: When the starting switch is ON, the controller end is OFF, but a voltage of approx.
20 - 30V is always flowing from starting switch BR, so if the voltage is measured at C01 (1), there is a voltage of 20 -30V 20-132